EUROM CEILINGHEAT 1500 RC Mode D'emploi page 13

USE

Check all safety instructions are met.

Check the master switch is 'off': O depressed.

Insert the plug into an undamaged, appropriate 220/240V earthed electric socket.

Now, switch the master switch on: I depressed. You will hear a beeping sound and the heater
is now on standby. The indicator light flashes. You will hear a beep each time you press a
switch or use the remote control.
Using via the control panel:

st
1 time pressing ON/OFF: heating starts, indicator light is on.

nd
2 time pressing ON/OFF: heating and lighting works, indicator light is on.

rd
3 time pressing ON/OFF: heating stops, lighting works and indicator light dims.

th
4 time pressing ON/OFF: back to standby position, indicator light flashes.

This cycle repeats itself upon repeated pressing.
Using via the remote control:

st
1 time pressing on HEAT: heating starts, indicator light is on.

nd
2 time pressing on HEAT: heating stops, indicator light flashes (on standby).

st
1 time pressing on LIGHT: lighting starts.

nd
2 time pressing on LIGHT: lighting dims.

Pressing OFF: all functions stop, indicator light flashes, (on standby).
The indicator light flashes therefore when on standby and is lit when the heating is on. It dims
when only using the lighting function or when the appliance is switched off via the master switch.
If you want to switch off the appliance, first put in on standby and then switch off via the master
switch. Then, pull the plug out of the electric socket.
Allow the heater to cool down.
When you use the appliance for the first time (or after a long time again), observe it during the
first 10 till 15 minutes to be sure that is works trouble-free.
The lighting elements may tilt in the casing a little. Allow the appliance to cool down before
adjusting these!
CLEANING - MAINTENANCE - SERVICE
Cleaning
This appliance consist of a robust and maintenance-free casing with a safety grill.
13
1. Master switch
2. 'Heat' indicator light
3. ON/OFF switch
4. Remote control receiver