EUROM CEILINGHEAT 1500 RC Mode D'emploi page 11

 Caution! Some parts of this product can become very hot during use and stay hot in a period
after use. That can cause burns. Do not let bare skin come into contact with hot
surfaces.Particular attention has to be given where children and vulnerable people are
present.
 Caution! Never leave the appliance unsupervised when in use. Do not use the appliance
with a programmer, timer or any other device that switches the appliance on automatically.
Also do not use the appliance with an external voltage regulator such as dimmer, speed
controller etc. That produces hazard too!
 Caution! This heater is not equipped with a device to control the room temperature. Do not
use this heater in small rooms when they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.
INSTALLATION
 Remove all the packaging material and check that all the parts are present. Ensure that
definitely no packaging material has remained around the 'head' of the radiator. Ensure
there is a clear work space and keep flammable materials out of the area.
 Check the device, the electrical cable and the plug for damage. Do not connect the device to
the mains if you notice any damage!
 Do not connect the terrace radiator to the mains before it is fully installed!

This appliance can be secured to a wall or ceiling using a suspension brace or it can be
suspended from the ceiling using the suspension system included in the pack.

The lowest point of the heater must have a
clearance of at least 180 cm above the ground.

Ensure that around the appliance there is at
least 50 cm distance to each wall and the
ceiling, with the exception of the wall or ceiling
to which the appliance is secured.

Ensure that at all times the appliance's
projection is never trained onto a wall or the
ceiling with a distance of less than 150 cm.

Your infrared projector is IP24 protected, i.e.,
protected against splashing water, but not
rainfall. Therefore select a place under cover outside.
Wall or ceiling assembly:

The patio projector must be secured to a sturdy, flat wall/ceiling: one that is strong enough to
bear the load of the patio projector long-term. Secure using the material included in the pack;
do not use any other supports or attachments!

At the right distance (see picture), drill 4 holes (Ø 8mm) for the plugs and secure one side of
the wall/ceiling support bracket (2) using the plugs (1) and the large screws (3) to the
wall/ceiling. The wall bracket must hang completely horizontal and level.

Unscrew the 2x3 screws from the round plates on the heater and remove the plates with the
suspension lines.

Now position the patio projector with its fixings (4) in line with the wall bracket and centralise.
The 2x2 small holes on the rear of the projector should now line up with the wall bracket.

11