Publicité
Les langues disponibles
Les langues disponibles
1
9
11
6. On both sides of the basic carrier bar (1) fold the
quick-release lever (11) down, hold and turn it to the
left. Fold the quick-release lever (11) up to the stop.
Press the red lever (10) down.
7. Tighten the screws (9) with the tool (4).
8. Place the covers (6) back on and lock them with
the key (3).
9. Follow the same procedure to fit the rear basic
carrier bar (2).
G
Warning
Each time the basic carrier bars are fitted to the
roof, before each trip and periodically during
longer journeys, check all the screws on the basic
carrier bars to make sure that they are secure,
and retighten them if necessary. Repeat these
checks at regular intervals as road surface
conditions dictate, and at least every 1550 miles
(2500 km) of continuous use.
Do not use any lubricant on the screws of the
basic carrier bars. The screws could work loose,
causing the basic carrier bars and the load to
become detached from your vehicle and thus
injure you and others and/or cause damage to
property, including damage to your vehicle.
Fitting the cover strip
If no accessories are fitted, then the cover strips (5)
should be attached in order to minimise wind noise.
Removal
1. Unlock the covers (6) with the key (3) and
remove them from the basic carrier bar (1).
2. On both sides of the basic carrier bars (1), lift the
10
red lever (10) up. Fold the quick-release lever (11)
down and turn it to the right.
3. Take the basic carrier (1) off of the vehicle roof.
M+P-03F-8021
4. Close the covers completely.
5. On both sides of the basic carrier bar (1) turn the
quick-release lever (11) to the left. Fold the
quick-release lever (11) up to the stop. Press the red
lever (10) down.
6. Place the covers (6) back on and lock them with
the key (3).
Note
When not in use, store the basic carrier bars in a
clean, safe place.
- 6 -
M+P-03F-8018
Publicité
