Preparation Of The Dishes; Selecting The Wash Cycle; Stopping The Wash Cycle And End Of Wash Cycle; Cold Rinse (Only Cold Versions) - Fagor EVO-CONCEPT CO-402BDD Instructions D'installation, D'utilisation Et D'entretien

5.1.5 Preparation of the dishes

Before washing the dishes, the preparatory steps below should be followed:
Remove the largest pieces of waste from the dishes before placing them in the baskets.
•
Wash glassware first.
•
Put the plates in the rack basket.
•
Place the glasses upside down.
•
Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
•
cutlery can be mixed.
Place the cutlery baskets in the lower baskets.
•

5.1.6 Selecting the wash cycle

Before starting the wash cycle, place the corresponding basket containing the dishes in the machine
and close the door. In the A models a wash cycle must be selected in order to start the wash. Each
wash cycle corresponds to a wash time that should be selected according to the user requirements.
Then press START and the wash cycle will start automatically.
In the B models, to start the wash process, select the wash cycle you wish to run by pressing one of
the three cycles. Each wash cycle (90"/120"/180") corresponds to a wash time that should be
selected according to the user requirements. Once the wash cycle is selected, the wash cycle will
start automatically
The door must be closed for the machine to start the wash cycle. For safety reasons,
if the door is open, the wash cycle will not start.

5.1.7 Stopping the wash cycle and end of wash cycle

The wash cycle can be stopped in the following ways:
By switching off the machine → the cycle stops completely.
•
By opening the door → when the door is closed, the cycle continues.
•
At the end of the wash cycle, remove the basket and leave the dishes to dry naturally. Remove the
dishes from the basket with clean hands, taking care not to burn yourself as the dishes are extremely
hot.

5.1.8 Cold rinse (only COLD versions)

The COLD versions have a cold rinse programme.
In the A models, to run this programme, keep the cycle selector switch set to cold rinse (D) for the
required time. While the switch is held in this position, the machine will run a rinse using cold water
from the mains supply.
In the B models, hold the button P3 once for 3 seconds and the machine will run a rinse using cold
water from the mains supply.

5.1.9 Drainage of the machine

The dishwashers have two types of drainage; gravity drainage or using a drainage pump, which is
optional. The drainage pipe must always be fitted on a siphon to prevent the return of odours.
5.1.9.1 Drainage by gravity
To drain the machine in this way, just remove the overflow from the machine and it will drain
naturally. For reasons of safety, this method of drainage should only be used with the machine
switched off.
37