Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
g HEADPHONES MIX control
Adjusts the balance of the monitor volume between the sound of the
channels selected for headphone CUE fader and the sound of the
master channel.
h SAMPLER VOLUME control
Adjusts the Serato DJ sampler deck's overall sound level.
Effect section
1
3
1 BEAT FX SELECT button
Select a beat effect to be applied to each channel. (Multiple effects
cannot be selected at the same time.)
2 SERATO DJ FX SELECT button
Select a Serato DJ effect to be applied to each channel. (Multiple
effects cannot be selected at the same time.)
3 EFFECT lever
The selected effect is applied to the corresponding channel while the
lever is tilted toward you. It is locked if the lever is tilted forward, and
the effect continues to be applied if the lever is released.
4 BEAT button
Set the beat fraction for synchronizing the effect sound.
Rear panel
e
1 MASTER 1 terminals
Connect powered speakers, etc., here.
Be sure to use these as balanced outputs. Be careful not to acci-
dentally insert the power cord of another unit.
2 MASTER 2 terminals
Connect to a power amplifier, etc.
10
En
4
3
2
4
5
8
6
9
7
c
5
6
2
[SHIFT] + press:
These adjust the effects' parameters.
5 LEVEL/DEPTH control
Adjusts the quantitative parameter of the effect.
6 SAMPLER FX ON button
If this is turned on, the selected effect is applied to the sampler
sound output from Serato DJ.
[SHIFT] + press:
Loads the Effect BANK setting to this unit.
For details on Effect BANK, see this product's operating instructions.
7 AUX FX ON button
If this is turned on, the selected effect is applied to the sound of AUX
input.
[SHIFT] + press:
Loads the Effect BANK setting to this unit.
For details on Effect BANK, see this product's operating instructions.
8 Effect section display
Displays the name of the currently selected effect and BPM, etc.
9 TAP button
Resets the effect time if the button is pressed and held when an
effect is selected in Serato DJ.
Press:
When the BPM measurement mode is set to [TAP], tap the button
with a finger to input the BPM manually.
Switches the BPM measurement mode to [TAP] when the measure-
ment mode is set to [AUTO].
[SHIFT] + press:
Switches the BPM measurement mode to [AUTO].
7
3
1
6
4
3 MASTER ATT level selector switch
Sets the attenuation level of the sound output from the [MASTER 1]
and [MASTER 2] terminals.
— [0 dB]: The level of the sound output from [MASTER 1] and
[MASTER 2] terminals is output without change.
— [–6 dB]: The level of the sound output from the [MASTER 1] and
[MASTER 2] terminals is decreased by half.
— [–12 dB]: The level of the sound output from the [MASTER 1] and
[MASTER 2] terminals is decreased by quarter.
5
a
9
8
b
d
Publicité
Chapitres
Table des Matières
