Technical Data; Ec Declaration Of Conformity - HSM Classic 411.2 Notice D'utilisation

Masquer les pouces Voir aussi pour Classic 411.2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19

10 Technical data

Cutting type
Shred size (mm)
Sa fe ty ra ting DIN 32757 – 1
Cutting ca pa ci ty ** (sheets), DIN A4 70 g/m
Cutting speed
Weight
Noise level (Idle running/ load)
Lo ading width
Voltage
Power for the maximum number of sheets
Dimensions W x D x H (mm)
Volume of shredded material bag
* HSM-specifi cation
** The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
The performance data in 80 g/m² is calculated.

EC Declaration of Conformity

The manufacturer HSM GmbH + Co. KG, Austraße 1 - 9, D-88699 Frickingen hereby declares that the machine,
referred to here as
document shredder HSM Classic 411.2
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards and technical specifi cations:
• EN 55014-1:2006
• EN 55014-2:1997 + A1:2001 + A2:2008
• EN 61000-3-2:2006
• EN 61000-3-3:1995 + A1:2001 + A2:2005
• EN 13849-1:2008
• EN 62233:2008
• EN 60950-1:2006 + A11:2009 + A1:2010
Frickingen, 01.03.2011
Rolf Gasteier - Technical Director
18
Strip cut
5.8
3.9
2
65 - 67
48 - 50
2
80 g/m
51 - 53
38 - 40
2
100 mm/s
74 kg
60 dB(A) / 68 dB(A)
• EN 61000-4-2:1995 + A1:1998 + A2:2001
• EN 61000-4-4:2004
• EN 61000-4-5:2006
• EN 61000-4-6:2007
• EN 61000-4-11:2004
• EN 50366:2003 + A1:2006
Classic 411.2
english
english
Cross cut
3.9 x 50
1.9 x 15
2
3
4
38 - 40
26 - 28
33 - 35
20 - 22
110 mm/s
60 dB(A) / 75 dB(A)
400 mm
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
2100 W
595 x 470 x 990
146 l
0.78x11
1 x 5
5
Level 6*
17 - 19
11 - 12
12 - 14
10
82 kg
09/2011

Publicité

Table des Matières
loading

Table des Matières