HSM Classic 411.2 Notice D'utilisation page 14

5 Commissioning
• Undo the wing screws securing the unit
during transportation.
• Open the door of the document shredder.
• Take the frame (A) and a waste bag.
• Place the waste bag on the frame and
fold over the top approx. 20 cm.
A
• Slide the frame (with bar B facing the
front of the cupboard) again into the
guide rails.
B
• Close the door of the document shredder.
• Plug the machine into a properly
installed socket.
14
6
Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Switching the paper shredder on
• Set mains switch at rear of paper
shredder to „I".
Green LED lights.
Paper shredder is ready for ope-
ration (standby)
Feed paper
The document shredder can also
be started by pressing the green
arrow button:
• Press briefl y:
Cutting device starts.
Automatic stop approx. 3 seconds
after the last piece of paper was
drawn in, or manual stop when
the stop button is pressed.
• Hold down for longer than
2 seconds:
constant operation without light
barrier function.
The cutting device runs until it is
switched off with the stop button.
Classic 411.2
english english
• Feed paper. See
„Technical data" for
sheet capacity.
The shredding pro-
cess is star ted by a
pho to –cell in the paper
feeding opening.
When the paper fee d
opening is free again,
the cut ting sy stem au-
to ma tical ly swit ches
off af ter app rox. 3 sec.
and returns to standby.
09/2011