Schulthess wmi 100 Notice D'installation page 32

Removing the transport securing device
f Before putting the appliance into service for the first
time, the transport securing devices on the front and
rear of the appliance must be removed.
CAUTION
In the case of slipping there is a risk of injury!
Front
f Unfasten and remove the four hex screws to the left
and to the right of the loading door with a 13 mm ring
spanner.
f Remove the red transport safety devices on both sides
of the door.
f On the left side, install the two oval head screws
supplied in the bag, in place of the hex screws.
f On the right side, re-install the two previously removed
hex screws.
Notice
The door will leak, without these four screws!
32
E NGLISH
Rear
f Undo the hexagon-head bolts with a 13 mm ring
spanner until the bolts are able to move freely.
f Remove the screws and all the sleeves..
CAUTION
f Transport the appliance only with the transport
securing device fitted.!
f Keep the transport securing device in a safe place for
possible future use (move).