Steinberg Systems SBS-LW-3000 Manuel D'utilisation page 11

EN
Instability (Error2)
By posting error2, the balance alerts you the weight is still unstable, which leads to
errors of measurement.
On / Off (I / O)
with the main switch I / o on the back of the device, you can turn the scale on. a
self-test begins.It begins with a screen test, which should display correctly 8.8.8.8.8.8.
then the maximum weight allowed by the balance (3000 g/2000g/200g).
after testing, the scale shows 0 and is ready for use.
To turn the scale off, press the button I / o again
Tare (TAR)
Place an empty container on the scale. wait 3 sec. Until the scale displays the weight
of the container. Press (Tar / CaL) to begin weighing ignoring the weight of the
container.
CAUTION
The maximum load is reduced by the weight of the empty container!
For example:
Container b = 50g
Max. Normal l = 200g,
Max. remaining L = l - b = 150g.
Place the weight slowly on the scale and remove it immediately in case of overload (
--------- displayed)
Counting mode (COU)
In counting mode, you can determine the number of units put on the scale according
to their weight. Place a sample on the scale. switch to counting by pressing (CoU /
aFF). with the (Tar / CaL) button, you can choose the number corresponding to
the quantity of pieces placed (10 to 500 in increments of 10,20,50,100,250,500)
Confirm by pressing (COU / AFF). You can now weigh in counting mode.
11
11