Connecting/Disconnecting - Panasonic CF-VEB081AU Instructions D'utilisation

Connecting/Disconnecting

Connecting
1
Connect the plug of the AC adaptor that came with the
wireless display to the DC-IN jack of the cradle and plug
the other end into an AC outlet.
CAUTION
Use only the specified AC adaptor and AC cord
with your wireless display.
Refer to the "Operating Instructions" accompa-
nying the wireless display for information on
proper handling of the AC adaptor and AC cord.
E
2
Slowly lower the wireless display and connect it to the
cradle firmly.
CAUTION
Connect the AC adaptor to a cradle.
Do not attempt to make connections if there is any object between the wireless
display and the cradle. Doing so could damage the wireless display and the
cradle.
Do not attempt to move the cradle when it is connected to the wireless display.
If the wireless display malfunctions while the cradle is attached, refer first to the
"Troubleshooting" of the "Operating Instructions" accompanying the wireless
display. If you still are unable to solve the problem, power off the wireless
display, disconnect the cradle (
display operates normally. If the wireless display operates normally, the cradle
may be malfunctioning. Contact your technical support office.
Disconnecting
1
Lift up the wireless display to remove it from the cradle.
8
below) and check to see if the wireless