Before First-Time Use; Assembly And Installation; Charging The Battery; Switching The Cordless - LIVARNO LUX 970-K Instructions D'utilisation Et Consignes De Sécurité

fire. They may explode or cause toxic
fumes.
Do not expose rechargeable batteries to
„
unlimited amounts of sunlight or heat.
Do not take rechargeable batteries apart or
„
short-circuit them.
Charge the battery at normal room
„
temperature (approx. 20 °C).
Use only an SELV mains adaptor for
„
charging.
z Before first-time use
Check that all package contents are present.
Inspect the cordless magnetic lamps
the USB charging cable
external damage. If you find any signs of
damage, do not use the cordless magnetic
lamps. Please contact Customer Service at
the address indicated.
Unpack all parts of the product. Remove the
packaging material. Keep the packaging in
a safe place out of the reach of children.
There is a risk of suffocation if children are
allowed to play with packaging material.
z Assembly and installation
Please note: Dispose of all packaging
material�
Take the magnetic holder with the adhesive
pad and pull off the protective strip (see
8
Fig. D). Now stick the magnetic holder in the
desired position. To ensure good adhesion,
make sure the surface is flat, dry and free of
grease. Fix the cordless magnetic lamp
the magnetic holder
integrated magnet
7
C).
Please note: Removing the adhesive pad
may cause damage to the surface in some
cases. We can accept no liability for such
damage. When the battery needs to be
recharged, the magnetic lamp can simply be
removed from the magnetic holder
Fig. C).
and
1
for any signs of
9
1
with the aid of the
8
in the casing (see Fig.
(see
8
The holes on the back have no function.
z Charging the battery
Risk of electric shock!
The cordless magnetic lamps
be recharged in dry indoor areas using an
SELV mains adaptor. Before using the
cordless magnetic lamp
please fully charge the battery. To do so, use
only the USB charging cable supplied
Plug the USB charging cable supplied
„
into the micro-USB socket
cordless magnetic lamp (see Fig. F).
To charge the lamp, connect the USB
„
charging cable
(5 VDC, max. 0.34 A).
Plug the USB mains adaptor into a power
„
outlet socket.
The charging time is approx. 2-3 hours. The
charge indicator
cordless magnetic lamp is fully charged. As
soon as the cordless magnetic lamp
fully charged, the charge indicator
green. You can then unplug the USB mains
adaptor from the power outlet socket and
disconnect the USB charging cable
the cordless magnetic lamp
z Switching the cordless

magnetic lamps ON/OFF/

Setting timer function

The cordless magnetic lamps have three
functions: Permanently on, 3-minute timer
to and 15-minute timer. For the permanently on
function, set the OFF/15M/3M/ON switch
to the ON position and press the ON/
4
OFF switch . For the 3-minute timer
2
function, set the OFF/15M/3M/ON switch
to the position 3M and press the ON/
4
OFF switch . The cordless magnetic lamps
2
will then switch off automatically after 3
minutes. For the 15-minute timer function, set
the OFF/15M/3M/ON switch
position 15M and press the ON/OFF switch
should only
1
for the first time,
1
on the
6
to a USB mains adaptor
9
remains red until the
5
1
5
9
�
1
to the
4
GB/IE/NI/CY/MT
�
9
9
is
shows
from
41