Nederman MagnaTrack S Manuel D'utilisation page 19

Anchor plate for nozzle model HB
The anchor plate should be fitted to the side of the vehicle
600 mm or 900 mm (23.6 in or 35.4 in) from the exhaust
pipe. If necessary this distance can be changed (+100 mm,
-25 mm / +4 in, -1 in) by loosening the adjusting screw in the
electromagnetic unit.
Nozzle model HB
Fit the nozzle leaf spring in the electromagnetic unit with the
adjusting screw as shown in the figure. Fit the hose in the
magnetic unit with the hose clip and cover with the rubber
ring.
Check that the nozzle, when
not connected to the vehicle, is
pointing forward in the driving
direction.
Fitting the standard
or HB-nozzle.
Locate the nozzle on to the exhaust pipe and secure the
electromagnetic unit on the anchor plate making sure the
hose is tensioned correctly. The hose should form a 90°
bend coming out from the exhaust pipe.
MagnaTrack S
Adjusting screw.
When the anchor plate has been
fixed in its correct position, it is
possible to adjust the nozzle by
loosening the adjusting screw
and moving the leaf spring some
upwards or downwards.
Alternative fitting
of HB-nozzle.
min. 300 mm
(min. 12 in)
Forward direction
of vehicle.
X = 600 (+100 / -25) mm / 23.6 (+4 / -1) in
or 900 (+100 / -25) mm / 35.4 (+4 / -1) in
depending on nozzle hose length.
GB
If necessary, adjust
the elastic cord length
so that the nozzle
comes in the required
position.
Fasten the quick-
coupling in the electro-
magnetic unit.
19