Noise Emission - Speck pumpen BADU 90 Série Instructions De Montage Et D'utilisation

1.1 Noise emission

Explanation concerning the measured noise level:
The sound pressure level is measured around the pump according to DIN
45635. The distance to the pump is I = 1 m.
The acoustic capacity reflects the total emission of noise by the pump. This is a
comparable value which does not depend on for example the distance to the
pump. The value is given according to the European directive 2000/14/EG. The
acoustic capacity is calculated from the measured sound pressure level.
Since both the acoustic capacity and the sound pressure level are expressed in
the same standard units one must be careful not to confuse the two values.
2. Safety
This Operation Manual contains basic instructions, which must be observed du-
ring mounting, operation and maintenance. Therefore the Operation Manual
should be carefully read before installation and start-up by the person in charge
of the installation as well as by all other technical personnel/operators and
should at all times be available at the installation site.
It is important that not only all general safety measures appearing under the
above heading "Safety" should be adhered to but also all other, specialized
safety instructions appearing under the other headings, e.g. for private use.
This device is not intended for use by people (including children) with limited
physical, sensory or mental capabilities or who lack experience and/or knowled-
ge unless they are supervised by a person responsible for their safety or have
received instructions on how to use the device from them. Children should be
supervised in order to ensure that they do not play with the device.
2.1 Symbols for Safety Instructions in the Operation Manual
All safety warnings contained in the Operation Manual which, when ignored,
may constitute danger for humans, are specially marked with general danger
symbols:
Safety symbol according to DIN 4844 - W 9
In case of electrical hazards they are specially marked with:
Safety symbol according to DIN 4844 - W 8
54