Environmental Protection - arjo Flowtron Excel Manuel D'utilisation

Precautions
For your own safety and the safety of the equipment, always take the following precautions:
• Do not expose the system to naked flames, such as cigarettes, etc.
• Do not store the system in direct sunlight.
• Do not use phenol-based solutions to clean the system.
• Make sure the system is clean and dry prior to use or storage.
• When the pump is in use the operator should remain in area in case the system alarms.
• If a serious incident occurs in relation to this medical device, affecting the user, or the
patient then the user or patient should report the serious incident to the medical device
manufacturer or the distributor. In the European Union, the user should also report the
serious incident to the Competent Authority in the member state where they are located.
Electromagnetic Compatibility (EMC)
This product complies with the requirements of applicable EMC Standards. Medical electrical
equipment needs special precautions regarding EMC and needs to be installed in accordance
with the following instructions:
• The use of accessories not specified by the manufacturer may result in increased
emissions by, or decreased immunity of, the equipment, affecting its performance.
• Portable and mobile radio frequency (RF) communications equipment (e.g. mobile/cell
phones) can affect medical electrical equipment.
• If this equipment needs to be used adjacent to other electrical equipment, normal
operation must be checked before use.
• For detailed EMC information contact Arjo service personnel.
Expected Service Life
The Flowtron Excel pump has an expected service life of seven years. To maintain the
condition of the pump have the pump serviced regularly according to the schedule
recommended by Arjo.
Do NOT use unapproved accessories or attempt to modify, disassemble or otherwise misuse
the Flowtron Excel system. Failure to observe this caution could result in injury, or in extreme
cases, death.
End of Life Disposal
• Garment material or any other textiles, polymers or plastic materials etc. should be sorted
as combustible waste.
• Pump units have electrical and electronic components should be disassembled and
recycled per Waste of Electrical and Electronic Equipment (WEEE) or in accordance with
local or national regulation.

Environmental Protection

Incorrect disposal of this equipment and its component parts, particularly batteries or other
electrical components, may produce substances that are hazardous to the environment. To
minimise these hazards, contact Arjo for information on correct disposal.
(iv)