MRA 4025066157549 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Spacers, M6 x 20 mm
2 Spacers, M6 x 15 mm
4 Phillips countersunk screws, M6 x 50
mm
4 Rubber washers, 16 x 6 x 2 mm
4 Caps, black, M6
4 O-rings, 4.5 x 1.5 mm
4 Finishing Washers M6
1 Edge protection strip with end sleeves
How to mount the screen on your motorbike:
1. Stand your motorbike up on a level surface.
2. Remove the four Allen screws on the front plastics (P1).
Before you start, remember that you will need the two long (20 mm) spacers for the two upper
fastening holes and the shorter (15 mm) spacers for the lower fastening holes.
3. Insert the screws supplied with the finishing washers through the two upper fastening holes on the
MRA screen (P2). Place each finishing washer the right way up for the screw cap to click into place.
4. Place the 2 mm rubber washers, 20 mm spacers and O rings onto the screws (P2).
5. Repeat for the lower fastening holes on the MRA screen using the 15 mm spacers.
6. Position the MRA screen, turn the fastening screws in and tighten them up.
7. Finally, place the caps onto the finishing washers.
8. Mount the edge protection strip onto the screen as shown in P4. Slide the end sleeves over the end
of the edge protector strip and gently squeeze the sleeves with a pair of pliers to secure the edge
protector strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA MT 10
Article No..
--- PH2 Phillips screwdriver
11181 Allen key, 5 mm
11180
11182
10792
11178
10992
11179
---
2
Required tools