Learn Mode - SURE petcare Microchip Pet Door Notice D'utilisation

6. Learn Mode

To start operation, the
your pet's microchip. This process is only required once for each pet, as the code is
permanently stored, even if the batteries are removed. Follow the simple step-by-step guide
below to carry out this process:
1. Remove the button cover. Press the learn button (
See Figure 1.
2. The locks will open, allowing a pet to pass through in either direction. A further indication
that the unit is in learn mode is the flashing of the icons on the LCD screen.
3. The next pet to pass through the flap from either direction, or to put its head into the tunnel
with its nose up to the door, will have its microchip number stored in the memory.
4. Once a pet's microchip number has been successfully learnt, the pet door reverts to
normal operation and the LCD screen will stop flashing. Once your pet moves away from
the pet door the locks will close.
For multiple pets, repeat the process until all pets' microchip numbers have been learnt. The
microchip numbers of up to 32 different pets can be stored in memory. Replace the button
cover when the learn process has been completed for each pet.
This method of learning is particularly convenient for uncooperative pets! Rather than having
to find your pet and pass it through the flap, you can simply set it to learn mode and leave until
it next decides to go through or put its head up to the door of its own free will.
To cancel learn mode (e.g. after pressing the learn button accidentally) simply press the learn
button ( ) again for around 1 second and the unit will revert to normal operation.
In order to learn a pet's microchip number, a sensor located in the tunnel must detect
a pet's presence to trigger the microchip reader. Therefore it is important to ensure
that your pet either puts its head into the tunnel or passes through the flap. No amount
of waving your pet in front of the door will have an effect.
To learn the Sure Petcare
tag in your hand and then place your hand inside the tunnel of the
Pet Door making sure that you touch the door. The unique code of the collar tag will be
stored in the memory after a few seconds.
SureFlap Microchip Pet Door needs to learn the unique ID code of
RFID Collar Tag carry out steps one to three above. Hold the collar
Figure 1
) for around 1 second and release.
7
SureFlap Microchip