SURE petcare Microchip Pet Door Notice D'utilisation page 24

15. Maintenance
The sensor that detects the presence of a pet in the tunnel is optical and is situated on the
inside roof of the tunnel, close to the flap. If these lenses become obscured by dirt, unreliable
operation and/or shortened battery lifetime may result. Wipe these lenses with a damp cloth
every couple of months.
Operation of the sensor relies on a reflection from the base of the tunnel, which should also
be kept reasonably clean. If you have a brown
the silver reflective sticker is kept free from dirt. If you notice that the sticker is missing please
contact Sure Petcare
When cleaning your
top draught excluder on the door. A build-up of pet hair on this area of the door can obstruct
the lenses of the pet door, causing the unit to be permanently scanning, and therefore drain
the batteries.
After cleaning, leave the
unit to settle before normal operation returns.
15.1 Removing the front panel of the
In the event that you need to access the inside of the pet door, for example to fit spare parts,
you can do this without removing the unit from its installation location by following the steps
below (as detailed in step 13 of the wall installation instructions, see section 7.5) –
1. Remove the button cover and the two screw caps at the bottom of the unit
2. Remove the four screws holding the front cover of the unit
customer service or replace with the spare sticker provided.
SureFlap Microchip Pet Door– please ensure to remove all hair from the
SureFlap Microchip Pet Door for approximately 10 seconds for the
SureFlap Microchip Pet Door, please ensure
SureFlap Microchip Pet Door
23