Timer Function; Cleaning And Care - MELINERA HG01313 Instructions D'utilisation Et Consignes De Sécurité

switch the product off completely, unplug the
power adaptor
3
The LEDs are not replaceable.
If the LEDs fail at the end of their lives, the
entire product must be replaced.
RISK OF EXPLOSION! Do
not use the product in explosive atmospheres
where flammable vapours, gases or dusts are
present.
Do not expose the product to any strong
vibrations or heavy mechanical stresses.
Make sure the 10 m lead wire
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
RISK OF INJURY! Make
sure that, when the LED tree
base plate and the ground spike
1
also removed, so that they do not present any
risk (e.g. risk of stumbling from the lead wire).
Installation
Note: Remove all packaging materials from the
product.
Remove the individual parts from the packag-
ing and mount the product according to figures
A–E. The site for the LED tree
lected in a way that it is erected on a solid,
level and vibration-free base. Anchor the LED
tree firmly to the ground and make sure that
8
the tree is stable!
Assembly without ground spike
(see fig. A1): Use four suitable screws and
dowels (not included) for the selected site
underground and mount the base plate
Make sure that the recess on the tube of the
base plate does not apply to the recess
1
when fixing!
Installation with ground spike
(see fig. A2): Anchor ground spike
ground and mount base plate
fixing the stand pipe
base plate , make sure to position the space
1
of the pipe exactly where the spike is fixed with
the screw.
from the socket.
is not laid
7
is removed, the
8
are
2
must be se-
8
2
1
2
to the
2
on it. When
1
on the pipe of the
5
Further steps for both types of
installation:
Attach stand pipe
tighten Hexagon screw
Hexagon key
Attach LED tree
tighten Hexagon screw
Hexagon key
Bend the individual branches of the LED tree
to the desired shape (see fig. D).
8
Plug the connector plug of lead wire into plug-
in power supply and tighten the screw connec-
tion, in order to prevent moisture from
penetrating inside. Then plug the power adaptor
into a socket (see fig. E).
3

Timer function

To switch on the timer function, press the timer
button after the product is connected to the
9
socket of power supply. The timer button
will light up when the timer function is activated.
The LED tree
6 hours and will be followed by a subsequent
pause of 18 hours. Afterwards, the LED tree
will light up again at its designated turn on time
for 6 hours followed by a subsequent pause of
18 hours.
To switch off the timer function, press the timer
button again and the light of the timer but-
9
ton will be turned off.
9
When the timer function is switched off, the
LED tree
8
product completely, the power adaptor
to be unplugged from the power socket.
.

Cleaning and care

SHOCK! First pull the power adaptor
the mains socket.
SHOCK! For reasons of electrical safety the
product must never be cleaned with water or other
liquids or immersed in water.
to base plate
5
with the help of
6
(see fig. B).
4
to stand pipe
8 5
with the help of
6
(see fig. C).
4
glows permanently for
8
glows continuously. To turn off the
DANGER OF ELECTRIC
3
DANGER OF ELECTRIC
GB/IE/NI
and
1
and
9
8
has
3
out of
7