Horizontal/Wall Mounting Kit - Ametek CHATILLON MT Série Manuel D'utilisation

3.5 Horizontal / Wall Mounting Kit
The Horizontal/Wall mounting assembly instructions are as follows:
3.5.1 Remove top plastic cap from top of column using a small screw driver.
3.5.2 Assemble two SCREWS (Item 3) to MTG PLATE (Item 2) and thread
on two LONG NUTS (Item 1).
3.5.3 Slide bottom mounting plate assembly to lower part of the MT test stand
column and fully tighten two screws using a 6mm hex key.
3.5.4 Repeat step 3.5.2 for the top mounting plate assembly.
3.5.5 Slide top mounting plate assembly to upper part of the MT test stand
column and fully tighten two screws using a 6mm hex key.
3.5.6 The four Ø8.5mm (Ø.33 in) holes in the two mounting plates are used for
mounting the MT test stand to a bench (horizontally) or wall (vertically).
3.5.7 Replace the top plastic cap to the column by pressing it on.
8
MT Series User Manual