Important Safety Instructions - ELNA 745 Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

Your 745 overlock machine is designed and constructed for
HOUSEHOLD use only. Read all instructions before using this overlock
DANGER
- To reduce the risk
of electrical shock:
1. Your overlock machine should never be
left unattended when plugged in.
2. Always unplug the machine from the
electrical outlet immediately after using
and before cleaning.
3. Always unplug before replacing light bulb.
Replace bulb with same type rated 15
Volts/5 watts.
4. Do not reach for the machine if it has
fallen into water. Unplug immediately.
5. Do not place or store machine where it
can fall or be pulled into a tub or sink. Do
not place it in or drop it into water or other
liquid.
WARNING
of burns, fire, electrical shock or injury:
Do not allow the machine to be used as a
1.
toy. Supervision is necessary when this
machine is used by or near children.
Use this machine only for its intended use
2.
as described in this manual. Use only
attachments recommended by the
manufacturer as described in this manual.
Never operate this machine if it has a
3.
damaged cord or plug, is not working
properly, has been dropped or damaged,
or dropped into water. Return the
machine to the nearest authorized dealer
or service center for examination, repair,
electrical or mechanical adjustment.
SAVE THESE INSTRUCTIONS
FOR USA/Canada
This appliance has a polarized plug (one blade wider than the other). To reduce the risk of
electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not modify the plug in any way.
Must use foot control 4C-335B, 4C-316B and /or YC-482M.
machine.
- To reduce the risk
Never operate the machine with any air
4.
opening blocked. Keep ventilation
openings of the machine and foot control
free from accumulation of lint, dust and
fibers.
Keep fingers away from all moving parts.
5.
Special care should be used around the
needle and cutting blades.
Do not use bent needles.
6.
Do not pull or push fabric while stitching.
7.
This may deflect the needle causing it to
break.
Switch off the machine when making any
8.
adjustment in the needle area, such as
threading needle, changing needle
position, threading looper, changing
presser foot, etc.
Always unplug the machine from the
9.
electrical outlet when removing covers,
lubricating or when making any other
servicing adjustments mentioned in this
instruction manual.
Never drop or insert any object into any
10.
opening.
Do not use outdoors. Always store your
11.
machine indoors.
Do not operate where aerosol (spray)
12.
products are being used or where oxygen
is being administered.
To disconnect, switch machine off, then
13.
remove plug from outlet.
Do not unplug by pulling on cord. To
14.
unplug, grasp the plug, not the cord.
This machine is equipped with a special
15.
connection cord which, if damaged, must
be replaced by an identical cord. This can
be obtained from an authorized dealer or
service center.
2