Heidolph UNIMAX 2010 Mode D'emploi page 22

IEI
Make sure, crimped edge (5) is plugged over shaker plate (6), thus positively locking both
parts with each other.
rack
(P/N 549-59000-00)
clamp for Erlenmeyer
flask
(P/N: refer to parts list)
Install Erlenmeyer flasks in holders:
Lightly tilt Erlenmeyer flasks to fit them under the clamp.
Before starting shaking, double check Erlenmeyer flasks for proper seat in their
clamps and all screws have been pulled tight.
3.3. Rack and holder for separating funnels
Rack and separating funnel holder safely hold size 250 ml, 500 ml, 1000 ml or 2000 ml
separating funnels on the shaker plate.
Components: rack, P/N 549.59000.00 and separating funnel holders (as required):
•
holder for size 1 (250, 500 or 1000 ml) separating funnels, P/N 549.57000.00
•
holder for size 2 (2000 ml) separating funnels, P/N 549.61000.00
One rack accepts the following number of separating funnel holders: 4 ea. 250 ml,
3 ea. 500 ml, 3 ea. 1000 ml or 2 ea. 2000 ml; a mix of various sizes may be used either.
Install holders:
separating funnel holder
(P/N 549-57000-00)
(P/N 549-62000-00)
rack
(P/N 549-59000-00)
•
Remove nuts (5) and washers (4) from part (1) & (2) bolts.
•
Plug part (1) and part (2) into the rack's holes, so that dimension "A" is about 25 mm less
than length "L" of the separating funnel; as to guarantee proper clamping of the separating
22