Preparing Trimmer For Operation; Assembling The Trimmer; Mounting The Bike Handle; Mounting And Removing The Deflector - Stihl FSA 130 Notice D'emploi

5 Preparing Trimmer for Operation

5 Preparing Trimmer for Operation
5.1 Preparing Trimmer for Operation
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Trimmer, @ 4.6.1.
– Deflector, @ 4.6.2.
– Mowing head or metal cutting attachment, @ 4.6.3 or
@ 4.6.4.
– Battery as described in the STIHL AR battery's
instruction manual or in the instruction manual for the
"AP belt bag with connecting cable".
► Check the battery as described in the STIHL AR battery's
instruction manual or in the instruction manual for the "AP
belt bag with connecting cable".
► Recharge the battery fully as described in the STIHL AL
charger's instruction manual.
► Clean the trimmer, @ 15.1.
► Mount the bike handle, @ 6.1.
► Mount the deflector, @ 6.2.1.
► Mount mowing head or metal cutting attachment, @ 6.3.1
or @ 6.4.1.
► Put on and adjust the STIHL AR battery, carrying system
or "AP belt bag with connecting
► Balance the trimmer,@ 7.4.
► Adjust the bike handle, @ 7.5.
► Check the controls, @ 10.1.
► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL servicing dealer.
There is a malfunction in the trimmer.
► If you cannot carry out this work: Do not use your trimmer
and contact your STIHL servicing dealer.
0458-726-9921-A
cable",@ 7.

6 Assembling the Trimmer

6.1

Mounting the Bike Handle

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1
3
2
4
► Remove the wingscrew (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp molding (2).
► Insert the wingscrew (1).
► Swing the handlebar (3) up.
► Tighten down the wingscrew (1).
► Take out the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gearhead, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6).
The loop handle (2) need not be removed again.
6.2

Mounting and Removing the Deflector

6.2.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
English
8
7
6
3
45