Fitting The Harness - Stihl FS 240 Notice D'emploi

English
Opening the filler cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the cap.
N
Filling Up with Fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
Fill up with fuel.
N
Closing the filler cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.
24

Fitting the Harness

The type and style of the
harness/shoulder strap depend on the
market.
The use of the shoulder strap is
described in the chapter on "Approved
Combinations of Cutting Attachment,
Deflector, Handle and Harness".
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Balance the machine – see
N
"Balancing the Machine".
Full harness
Fitting the full harness is described in
detail in the instruction sheet supplied.
1
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Balance the brushcutter.
N
1
2
FS 240, FS 240 R