Becker Centronic VarioControl VC320 Notice De Montage Et D'utilisation page 27

Deleting all transmitters (except the master
transmitter)
Press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Re-press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Re-press the programming button on the master transmitter for 10 seconds.
▻ The sun protection shifts to confirm.
► All transmitters (except the master transmitter) are now deleted from the
radio receiver.
Overwriting the master
Switch off the power supply to the radio receiver for 10 seconds, then switch it
back on.
▻ The radio receiver remains ready for programming for 3 minutes.
To ensure that the new master transmitter is programmed in
the desired radio receiver only, all other receivers which are
connected to the same power supply must be deactivated
from the programming mode. To do so, after switching back
on the power, execute a drive or stop command using the
transmitter for the given receivers.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The sun protection shifts to confirm.
► The new master transmitter is now programmed and the old master
transmitter deleted.
27 - en