Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 26

English
Stop knob
Stop seat
Stop block
Fig. 25-b
15. Setting the cutting depth (Fig. 25-b)
The depth of cut can be preset for even and repetitive
shallow cuts.
(1) Adjust the cutting head down until the teeth of the
blade are at the desired depth.
(2) While holding the upper arm in that position, turn the
stop knob until it touches the anchor plate.
(3) Recheck the blade depth by moving the cutting head
front to back through the full motion of a typical cut
along the control arm.
NOTE
If the anchor plate becomes loose, it can interfere with
raising and lowering the cutting head. The anchor
plate must be tightened in horizontal position as
shown in Fig. 25-b.
16. The laser guide
WARNING
● For your own safety, never insert the battery to
tool until all the adjustment steps are complete
and you have read and understood the safety
and operational instructions.
● Your tool is equipped with a laser guide using a
Class 1M laser guide. The laser guide allows you
to preview the saw blade path on the workpiece
to be cut before starting the miter saw. The saw
must be connected to the power source and the
laser on/off switch must be turned on for the
laser line to show.
26
Anchor plate
(1) Avoid direct eye contact
WARNING
* AVOID EXPOSURE
Laser radiation is emitted from this aperture.
*
CAUTION
● Use of controls or adjustments or performance
of procedures may result in hazardous radiation
exposure.
● The use of optical instruments with this product
will increase eye hazard.
WARNING
Do not attempt to repair or disassemble the
laser. If unqualifi ed persons attempt to repair
this laser product, serious injury may result. Any
repair required on this laser product should be
performed by a qualifi ed service dealer.
Fig. 26