Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 22

English
Saw blade
Table insert
[Right bevel angle cutting]
Fig. 16-c
Table inserts are installed on the turntable. When
shipping the tool from the factory, the table inserts
are so fi xed that the saw blade does not contact them.
The burr of the bottom surface of the workpiece is
remarkably reduced, if the table insert is fi xed so that
the gap between the side surface of the table insert
and the saw blade will be minimum. Before using
the tool, eliminate this gap in accordance with the
following procedure.
(1) Right angle cutting
Loosen the three 4 mm machine screws, then secure
the left side table insert and temporarily tighten
the 4 mm machine screws of both ends. Then fi x a
workpiece (about 7-7/8" (200 mm) wide) with the vise
assembly and cut it off . After aligning the cutting
surface with the edge of the table insert, securely
tighten the 4 mm machine screws of both ends.
Remove the workpiece and securely tighten the 4
mm center machine screw. Adjust the right hand table
insert in the same way.
(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in
Fig. 16-b and Fig. 16-c following the same procedure
for right angle cutting.
CAUTION
After adjusting the table insert for right angle
cutting, the table insert will be cut to some extent
if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust
the table insert for bevel angle cutting.
2. Use of sub fence (A)
WARNING
The sub fence (A) must be extended when
making any right angle bevel cut. Failure to
extend the sub fence (A) will not allow enough
space for the blade to pass through which could
result in serious injury. At extreme miter or bevel
angles the saw blade may also contact the fence.
22
4 mm
machine
screw
NOTE
3. Use of sub fence (B)
Sub fence (A)
Lock knob
Fig. 17
This power tool is equipped with a sub fence (A).
In the case of direct angle cutting and left bevel angle
cutting, use the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
When right angle cutting, loosen the lock knob, then
slide the sub fence (A) outward, as shown in Fig. 17.
When you slide sub fence (A) outward, if enough
space cannot be secured or the sub fence (A) comes
into contact with other parts of the tool including the
motor, fully remove sub fence (A) from fence (A). Also,
make sure to remove the lock knob from fence (A).
When transporting the saw, always secure the sub
fence (A) in the collapsed position and lock it.
WARNING
The sub fence (B) must be extended when
making any left angle bevel cut. Failure to extend
the sub fence (B) will not allow enough space for
the blade to pass through which could result in
serious injury. At extreme miter or bevel angles
the saw blade may also contact the fence.
Sub fence (B)
Fence (B)
Fig. 18
Fence (A)
Lock knob