Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 29

(1) The vise assembly can be mounted on the base.
(2) Turn the upper knob and securely fi x the workpiece in
position (Fig. 31).
NOTE
When using the vise, make sure that the tool is free of
any excessive contact when the unit is swung or slid.
WARNING
Always fi rmly clamp or vise to secure the
workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily
harm.
3. Cutting Operation
ⓐ
Marking
ⓐ
(pre-marked)
(Front view)
ⓐ
Adjusting line
(1) As shown in Fig. 32 the width of the saw blade is the
width of the cut. Therefore, slide the workpiece to
the right (viewed from the operator's position) when
length ⓑ is desired, or to the left when length ⓐ is
desired.
If a laser marker is used, align the laser line with the
left side of the saw blade, and then align the ink line
with the laser line.
(2) Once the saw blade reaches maximum speed,
push the handle down carefully until the saw blade
approaches the workpiece.
ⓑ
Saw blade
Marking
ⓑ
(pre-marked)
ⓑ
Fig. 32
(3) Once the saw blade contacts the workpiece, push the
handle down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth,
turn the power tool OFF and let the saw blade stop
completely before raising the handle from the
workpiece to return it to the full retract position.
CAUTION
Increased pressure on the handle will not
increase the cutting speed.
On the contrary, too much pressure may result in
overload of the motor and/or decreased cutting
effi ciency.
WARNING
● Confi rm that the trigger switch is turned OFF
and the power plug has been removed from the
receptacle whenever the tool is not in use.
● Always turn the power off and let the saw blade
stop completely before raising the handle from
the workpiece.
If the handle is raised while the saw blade is still
rotating, the cut-off piece may become jammed
against the saw blade causing fragments to
scatter about dangerously.
● Every time one cutting or deep-cutting operation
is fi nished, turn the trigger switch off , and check
that the saw blade has stopped. Then raise the
handle, and return it to the full retract position.
● Be absolutely sure to remove the cut material
from the top of the turntable, and then proceed
to the next step.
● Continued cutting operation can result in
overload of the motor. Touch the motor and if
it's hot, stop your cutting operation at once and
rest for 10 minutes or so, and then restart your
cutting operation.
4. Cutting wide workpieces (Slide cutting)
Pull forward
1
Push backward
3
English
Handle
Press down
2
Workpiece
Fig. 33
29