Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 31

NOTE
If 48° left bevel is necessary, slide the bevel stop plate
(A) clockwise away from the stop block (A) to achieve
48° left bevel.
If 48° right bevel is necessary, slide the bevel stop
plate (B) counterclockwise away from the stop block
(B) to achieve 48° right bevel.
Also, use anchor plate. (see Fig. 25-b)
WARNING
When the workpiece is secured on the left or
right side of the blade, the short cut-off portion
will come to rest on the right or left side of the
saw blade. Always turn the power off and let the
saw blade stop completely before raising the
handle from the workpiece.
If the handle is raised while the saw blade is still
rotating, the cut-off piece may become jammed
against the saw blade causing fragments to
scatter about dangerously.
When stopping the bevel cutting operation
halfway, start cutting after pulling back the
motor head to the initial position.
Starting from halfway, without pulling back,
causes the lower guard to be caught in the
cutting groove of the workpiece and to contact
the saw blade.
CAUTION
● If not tightened fi rmly enough the motor head
might suddenly move or slip, causing injuries. Be
sure to tighten the motor head section enough so
it will not move.
● Always check that the bevel lock handle is
secured and the motor head is clamped. If you
attempt angle cutting without clamping the
motor head, then the motor head might shift
unexpectedly causing injuries.
6. 33.9° Set pin (A) for crown mouldings (Fig. 34)
(1) Push the bevel set pin (A) in towards the rear of the
machine.
(2) Loosen the bevel locking handle.
(3) Tilt the cutting head until the set pin (A) stops the
bevel angle at 33.9° on the bevel scale.
(4) Tighten the bevel locking handle to lock the cutting
head in position. (see Fig. 34)
7. Miter cutting procedures
Turntable
Miter scale
Indicator
Turn the
(For miter scale)
turntable
(1) Unlock the miter table by lifting up on the miter lock
handle.
(2) While pressing down on the positive stop lock button,
grasp the miter lock handle and rotate the table left or
right to the desired angle.
(3) Once the desired miter angle is achieved, release the
positive stop lock button and press down on the miter
lock handle to secure the table into position.
(4) If the desired miter angle is NOT one of the nine
positive stops noted below, please see the Miter
detent override button section on page 23.
(5) Turn the laser guide on and position the workpiece on
the table for pre-alignment of your cut.
CAUTION
Always check that the miter lock handle is
secured and the turntable is clamped.
If you attempt angle cutting without clamping
the turntable, then the turntable might shift
unexpectedly causing injuries.
NOTE
○ Positive stops are provided at the right and left of the
0° center setting, at 15°, 22.5°, 31.6° and 45° settings.
Check that the miter scale and the tip of the indicator
are properly aligned.
○ Operation of the saw with the miter scale and indicator
out of alignment will result in poor cutting precision.
8. Compound cutting procedures
Compound cutting can be performed by following the
instructions in 5 to 7 above. For maximum dimensions
for compound cutting, refer to "SPECIFICATIONS"
table on page 14.
English
Positive stop
lock button
Tighten
Miter lock
handle
Fig. 36
31