Before Cutting - Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi

WARNING
Operating the tool without wearing proper eye
protection may result in serious injury.
AFTER INSTALLING THE POWER SUPPLY (BATTERY)
TO THE TOOL, CHECK THE OPERATION OF THE
TOOL AS FOLLOWS:
7. Electric brake
This tool is equipped with an electric brake which will
typically stop the blade within 5 seconds after the
trigger switch is released.
Occasionally, there will be a delay in the brake
engaging which will result in a longer blade stopping
time. On rare occasions, the brake may not engage at
all and the saw blade will coast to a stop.
If the brake fails to engage frequently, depress and
release the trigger switch to turn the tool on and off
4 or 5 times. If the brake still does not engage, have
the tool serviced at a metabo HPT authorized service
center.
Always confi rm that the saw blade has completely
stopped before raising it from the workpiece.
The brake is not a substitute for a properly functioning
lower guard. Check the function of the lower guard
before each use. Serious personal injury may occur
if the lower guard does not move smoothly and cover
the blade properly.
WARNING
Please be aware of the reaction of the Motor
Head (Fig.2) when the brake is activated. Braking
causes the Motor Head to jerk downward and
the user should be prepared for this reaction,
especially when the trigger switch is released
before the blade is completely down. Failure to
be familiar with, and prepared for, the operational
characteristics of the tool may cause serious
injury.
8. Trial Run
After confi rming that no one is standing behind,
the power tool start and confi rm that no operating
abnormalities exist before attempting a cutting
operation.
9. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for
defl ection to confi rm that the blade is not noticeably
unstable; otherwise vibrations might occur and cause
an accident.
AC/DC adapter
1. Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation are adequate.
2. To prevent electric shock, connect to a power source
equipped with a ground fault circuit breaker.
3. Prior to use, make sure that the DC cord insulation is
not torn or that the case is not cracked.
Do not use the product if there is a break in the DC
cord, the insulation is torn, or the case is damaged.
4. Before starting operation, make sure that the vicinity
of the box's vent is free from any wood shavings or
iron powder.
Also, do not use in locations where iron powder is
abundant, or in areas where there is rain, snow or
other water sources that could wet the product.
5. Make sure there are no solid metal material or liquid
in the adapter box. Failure to do so may result in
damage.
6. Be careful not to step on the box. Also, make sure the
box is placed in a location where it won't be stepped
on. Do not place in a location where the box could be
immersed in water when it rains.

BEFORE CUTTING

1. Positioning the table insert
4 mm
machine
screw
[Right angle cutting]
Fig. 16-a
4 mm
Saw blade
machine
screw
[Left bevel angle cutting]
Fig. 16-b
English
Saw blade
Table insert
Table insert
21