Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 33

(2) Setting to cut crown moldings at positions 2 and 3
in Fig. 38 (see Fig. 40; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the lower surface
(Ⓑ in Fig. 37) contacts the fence as in Fig. 42.
Head
1
Miter angle
scale
Turntable
2
Fence (B)
Base
35.3°
31.6°
30°
33.9°
Bevel angle scale
4
Fence (A)
Base
Fig. 39
Head
Bevel angle scale
3
Miter angle scale
Turntable
Fig. 40
Fence
Ⓐ
Fence
Ⓑ
(3) Setting to cut crown moldings at positions 1 and 4
in Fig. 38 (see Fig. 43; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the upper surface
(Ⓑ in Fig. 37) contacts the fence as indicated Fig. 45.
(4) Setting to cut crown moldings at positions 2 and 3
in Fig. 38 (see Fig. 44; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the lower surface
(Ⓐ in Fig. 37) contacts the fence as in Fig. 46.
English
Ⓑ
Table on base
Fig. 41
Ⓐ
Table on base
Fig. 42
35.3°
31.6°
30°
33.9°
35.3°
31.6°
30°
33.9°
33