Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi page 32

English
CAUTION
Always secure the workpiece with the right or left
hand and cut it by sliding the round portion of the
saw backwards with the left hand.
It is very dangerous to rotate the turntable to the
left during compound cutting because the saw
blade may come into contact with the hand that
is securing the workpiece.
In case of compound cutting (angle + bevel) by
left bevel, extend the sub-fence (B) fully before
cutting operation.
In case of compound cutting (angle + bevel) by
right bevel, extend the sub-fence (A) fully before
cutting operation.
Please confi rm that sub fence (A) (B) does not
interfere with other parts before attempting
compound cutting. If there is any interference,
remove either sub fence (A) or (B).
9. Crown molding cutting procedures
Fig. 37 shows two common crown molding types
having angles of (θ) 38° and 45°.
For the typical crown molding fi ttings, see Fig. 38.
Wall
Ceiling
Wall
1
Inside corner
The table below shows the miter angle and the bevel
angle settings that are ideal for the two crown molding
types.
NOTE
For convenience, positive stops are provided for the
miter setting (left and right 31.6°) positions.
32
Ⓐ Upper surface
ceiling
Ⓑ Lower surface
Fig. 37
2 3 4
Outside corner
Fig. 38
For miter cut setting
If the turntable has been set to either of the angles
described, move the turntable adjusting miter lock
handle a little to the right and left to stabilize the
position and to properly align the miter angle scale
and the tip of the indicator before the operation starts.
For bevel cut setting
Tighten the bevel lock handle and check that the
position is stable and that the bevel angle scale and
the tip of the indicator are properly aligned. Then
tighten the clamp lever.
Type of Crown Molding
To process crown molding at
positions 1 and 4 in Fig. 38.
Miter Angle Setting
Bevel Angle Setting
To process crown molding at
positions 2 and 3 in Fig. 38.
Miter Angle Setting
Bevel Angle Setting
(1) Setting to cut crown moldings at positions 1 and 4
in Fig. 38 (see Fig. 39; tilt the motor head to the left):
1 Turn the turntable to the right and set the Miter Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the upper surface
(Ⓐ in Fig. 37) contacts the fence as indicated in
Fig. 41.
45° Type 38° Type
right right
35.3° 31.6°
left left
30° 33.9°
left left
35.3° 31.6°
left left
30° 33.9°
35.3°
31.6°
30°
33.9°