Cutting Procedures - Metabo HPT C 7UR Instructions De Sécurité Et Mode D'emploi

3. Regulating the guide (Rip fence) (Fig. 10, 11)
Install the wing bolt (B) and lock spring on the base. Insert the guide into the base, move it left and right and adjust
the cutting position. Tighten the wing bolt (B) and fi x the guide. The guide can be installed either from the left or the
right side of the main body.
Fig. 10
4. Using the dust collector
To use the vacuum cleaner to gather up saw dust,
attach the suction hose to the dust collector which
is attached to the main unit by M4 screw. When
attaching the dust collector always be sure to change
the lever to the short type at this same time (Fig. 12).
CAUTION:
Continuing to use the lever that was attached to
the main unit prior to shipping from the factory
will cause it to bind on the dust collector and will
interfere with the lower guard operation.

CUTTING PROCEDURES

WARNING:
● Never touch the moving parts.
● Should the saw blade be stopped or make an abnormal noise during operation, turn off the switch
immediately.
● Don't remove circular saw from work piece during a cut while the saw blade is moving.
● Always wear eye protection with side shields that meets the requirements of ANSI Standard Z87.1.
Ordinary eyeglasses do not provide adequate protection.
● Avoid cutting any material like metal, etc., that give off sparks.
● Do not use any abrasive wheels.
● Use only blade diameter specifi ed on the product nameplate.
.........................Optional Accessory
Wing Bolt (B)
Lock
Spring
Base
.........................Optional Accessory
Wing Bolt (B), Lock Spring
Fig. 11
2
Lower guard lever
(short type)
1
Lower guard lever
M4 screw
English
Base
Guide
(Rip Fence)
Dust collector
3
Fig. 12
13