Publicité
Les langues disponibles
Les langues disponibles
Register Function
CV1
Loco address
CV2
Starting voltage
voltage for speed setting 1 - if loco starts
only at a higher speed setting, increase
value. With "Back-EMF" function active,
the factory pre-set value should not be
changed.
CV3
Acceleration (1 = fast, 255 = slow)
CV4
Braking (1 = fast, 255 = slow)
Hint: When programming with the 55015 Universal Remote, the following CVs
Hint: When programming with the 55015 Universal Remote, the following CVs
are programmed by input of the number of the desired CV in CV6 and then
are programmed by input of the number of the desired CV in CV6 and then
input of the desired function value in CV5 (see example below).
input of the desired function value in CV5 (see example below).
CV5
Max. voltage
Voltage for highest speed step - if a
lower top speed is desired, decrease
value. With "Back-EMF" function active,
the factory pre-set value should not
be changed.
CV5
after input of CV6
function value for CV to be programmed
CV6
CV to be programmed
CV29
Configuration
Normal direction:
4 = Analog and digital,
factory-programmed speed steps
0 = Digital only, factory-programmed
speed steps
20 = Analog and digital,
user-programmed speed steps
16 = Digital only, user-programmed
speed steps
Reversed direction:
5 = Analog and digital,
factory-programmed speed steps
1 = Digital only, factory-programmed
speed steps
21 = Analog and digital,
user-programmed speed steps
17 = Digital only, user-programmed
speed steps
With "Analog and digital:"
- Loco can operate on analog and
digital layouts
With "Digital Only:"
- Normal operation on digital layouts.
- Operation on analog layouts not
possible.
CV51
Command for steam terminal
0 = control via lighting button
1 = control via button 1
(buttons F2-F8 not used)
9 = control via button 1
(buttons F2-F8 used)
10 = control via button 2
11 = control via button 3
12 = control via button 4
13 = control via button 5
14 = control via button 6
15 = control via button 7
16 = control via button 8
64 = control via lighting button
(On only when reversing)
65 = control via button 1
(On only when reversing)
128 = control via lighting button
(On only when moving forward)
Available
Factory
values
pre-set
(00..22)
[3]
(0..255)
[0]
(1..255)
[3]
(1..255)
[3]
(1..255)
[255]
[4]
[13]
17
Publicité
