Preparing Hedge Trimmer For Operation; Charging The Battery, Leds; Charging The Battery - Stihl HSA 56 Notice D'emploi

English
components may no longer function properly or safety
devices may be rendered inoperative. This can result in
serious injuries.
► Clean the hedge trimmer, cutting blades, battery and
charger as described in this instruction manual.
￭ If the hedge trimmer, cutting blades, battery or charger are
not serviced correctly, components may no longer
function properly or safety devices may be rendered
inoperative. This can result in serious or fatal injuries.
► Do not attempt to service or repair the hedge trimmer,
battery or charger.
► If the hedge trimmer, battery or the charger require
servicing or repairs: Contact your STIHL servicing
dealer.
► Maintain the cutting blades as described in this
instruction manual.
￭ The user can be cut while cleaning or servicing the sharp
cutting blades. This can result in personal injury.
► Wear work gloves made of durable material.
5 Preparing Hedge Trimmer for
Operation
5.1

Preparing Hedge Trimmer for Operation

Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Hedge trimmer, @ 4.6.1.
– Cutting blades, @ 4.6.2.
– Battery, @ 4.6.3.
– Charger, @ 4.6.4.
► Check the battery, @ 9.2.
► Fully charge the battery, @ 6.1.
► Clean the hedge trimmer, @ 14.1.
► Check the controls, @ 9.1.
42
5 Preparing Hedge Trimmer for Operation
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL servicing
dealer.
Malfunction in hedge trimmer.
► If you cannot carry out this work: Do not use your hedge
trimmer and contact your STIHL servicing dealer.

6 Charging the Battery, LEDs

6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see www.stihl.com/
charging-times.
The charging process starts automatically
when the plug is inserted in a wall outlet and
the battery is fitted in the charger. The
charger switches itself off automatically when
the battery is fully charged.
The battery and charger heat up during the charging
process.
2
4
1
► Insert the plug (6) in a convenient wall outlet (7).
The charger (3) runs a self test. The LED (4) glows green
for about 1 second and then red for about 1 second.
► Lay the connecting cable (5).
3
7
6
5
0458-714-9621-B