Operating The Machine; Starting Off; Operating Safety Tips; Connecting A Vacuum Cleaner - Menzer TBS 225 Mode D'emploi

could be fatal.
distract you while sanding.
your place of work is properly aired so as to reduce dust levels.

2.3 OPERATING SAFETY TIPS

This drywall sander should only be used by skilled professionals who have carefully read and understood
pours. Extended inhalation of dust generated from construction work is harmful to the lungs. Also wear
removed from the operating area of the drywall sander.
ther be fully inserted or completely removed from the area that is to be treated before sanding can begin.
Only use this drywall sander for the treatment of dry surfaces.
attempt to carry out jobs too far above your head as this could result in you losing your balance.
Always hold the machine with both hands lest you lose control of the tool and cause damage.
that no parts have broken or fallen off of the machine. These factors could impede the operation of the
drywall sander.
Ensure that the power cable is always outside the surface area that is being treated.
The sanding of lead paints or coatings can release toxic gases and should either be carried out by a pro-
fessional with appropriate safety equipment or be avoided entirely.
then should you set the machine aside. Always store the drywall sander in a dry room. During breaks in
the power supply.
Immediately switch off the machine if it begins to make unusual noises or vibrations. Have repairs carried
4 EN

3. OPERATING THE MACHINE

3.1 STARTING OFF

has been transported:
already been placed inside the vacuum cleaner.
Make sure that no power cables or hoses will get in the way of your work.
-
Attach a suitable sanding disc to the driving disc of the drywall sander.
Check that the On/Off switch is set to Off. The machine can now be plugged in to a power supply.
-
3.2 OPERATING THE MACHINE

3.2.1 Connecting a vacuum cleaner

vacuum cleaner.
-
Please note that the use of an unsuitable vacuum cleaner can increase the concentration of dust particles
in your working environment to such an extent that you may suffer damage to your lungs.

3.2.2 Operating the drywall sander

Starting up:
front grip and with your right hand on the main handle. Press and hold the round safety switch on the side
on the underside of the tool. The driving disc will only start to rotate once both buttons are pressed at the
same time. Be prepared for the machine's driving disc to start rotating.
Shutting down:
Release both buttons to switch off the machine. The driving disc will continue to spin for a few moments.
Make sure that the driving disc has stopped spinning before you put the sander aside or set it down.
EN 5