Set Function - afx light BARLED 1215 Manuel D'utilisation

Sound FUNCTION
SET FUNCTION
‐ [REST] : To load the factory setup.
‐ Press [ENTER] and do the key code : [UP, DOWN, UP, DOWN] then press [ENTER]
‐ [ID] : ID address setting, Press [ENTER], press [UP] / [DOWN] to choose [ON] to allow ID address function, [OFF] close
ID address function
‐ [RGBW] : color deviation correcting setting, Press [ENTER], press [UP] /[DOWN] to choose [ON] to allow color
deviation correcting function,[OFF] not allow. the proportion of RGBW colors can be set in the menu [CAL2]
‐ [DIM] : non‐linear dimming setting, Press [UP] /[DOWN] to choose : [OFF] close dim speed, [DIM1] to [DIM9] to
choose speed ( speed 1 (fast ), ....., speed94 (slow), as the speed is slower as dimming softer.
‐ [DV] : Digital photography color choosen, Press [ENTER], and use [UP] /[DOWN] to choose between [NTSC] or [PAL]
CAL1 FUNCTION ( WHITE BALANCE FUNCTION )
‐ Choose [CAL1] and press [ENTER]
‐ Press [UP] /[DOWN] to choose [WT1~11] then press [ENTER] to set up to 11 different temperature of white color
‐ Press [ENTER] to choose [Red], [Green], [Blue], [White]
‐ Press [UP] /[DOWN] to choose value [0~255]
CAL2 FUNCTION ( COLOR DEVIATION CORRECTING SETTING )
‐ Choose [CAL2] then press [ENTER] to [RGBW]
‐ Press [ENTER] to choose [Red], [Green], [Blue], [White]
‐ Press [UP] /[DOWN] to choose the proportion of colors [0~510]
‐ When the RGBW function is on ( menu SET ) and when on DMX RGB =255,255,255, the white color is the one set in
CAL2 function
© Copyright LOTRONIC 2014
( Sound control Strobe)
( Sound control brightness)
( Sound control color changing)
‐ Choose [SET] and press [ENTER]
‐ [UPLD] : sending edit program value from current master unit to slave
unit : To do it, press [ENTER] then do the key code [UP, DOWN, UP,
DOWN] and press [ENTER], light turn to yellow, means data was
sending meanwhile there will show the speed of upload, light will turn
to green when finished sending, and the slave unit will turn to yellow
too when receive the data,and turn to green when finished receiving. if
the slave unit protect to yellow,it means fail receiving, please cut off
the power and receive again.
BARLED1215 Page 6