Installation Instructions; Style 1 - Freestanding Outdoor Grill Installation - KitchenAid KFRS271T Instructions D'installation Et Guide D'utilisation Et D'entretien

The supply line shall be equipped with an approved shutoff valve.
This valve should be located in the same area as the grill and
should be in a location that allows ease of opening and closing.
Do not block access to the shutoff valve.The valve is for turning
on or shutting off gas to the grill.
A
A. Gas supply line
B. Shutoff valve "open" position
C. To grill
LP Gas Conversion Using a Local LP Gas Supply
Conversion must be made by a qualified person. A qualified
Natural gas technician shall provide the LP gas supply to the
selected grill location in accordance with the National Fuel Gas
Code ANSI Z223.1/NFPA 54 -latest edition, and local codes.
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
1. Unpack grill. Remove all packaging materials and remove grill
from wooden skid.
2. Move grill into desired outdoor location.
3. Open the hood.
Attach Side Shelf (on some models)
4. Open doors below grill and remove carton. Unpack side
shelf.
5. Locate 4 screws. Install 2 screws in the top 2 holes on each
side of the grill. Leave screws away from side of grill about
¼" (0.64 cm).
B
C

INSTALLATION INSTRUCTIONS

Style 1 - Freestanding Outdoor Grill Installation

To convert to LP gas, the LP Gas Conversion Kit Part Number
W10118099 must be used. Follow instructions included with kit.
A
A.Grill gas pipe
B. New CSA International approved
"outdoor" flexible gas supply line
C. Rear of grill
D. To local gas supply
LP Gas Conversion Using a 20 lb LP Gas Fuel Tank
To convert to LP gas, the LP Gas Conversion Kit Part Number
W10118099 must be used. Follow instructions included with kit.
A 20 lb LP gas fuel tank must be purchased separately.
6. Install side shelf on left side of the grill. Position the side shelf
so that the large end of the keyhole slots are over the screws.
Place shelf onto the 2 mounting screws. Let the shelf slide
down so the screws are in the narrow neck of the slots.
A
A. Top of side shelf
B. Keyhole slot
C. Front of side shelf
D. Side of grill
7. Install the bottom 2 screws and tighten.
8. Tighten the top 2 screws.
B
C
D
B
C
D
11