ITW Orbitalum GF 4 Traduction Du Mode D'emploi Original page 88

enGLISH
Operation
WARnInG!
ATTenTIOn!
ATTenTIOn!
88
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Flying, hot and sharp-edged chips, pipe surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not reach into the rotating tool during working.
X never work without the saw chip guard mounted.
X Wear recommended protective clothing.
X At the end of each working cycle switch off the machine, wait until the machine/tool
stops running and pull the mains plug. Remove chips with tightfitting safety gloves (in
accordance with DIN EN 388 and EN 407) using suitable tools (e.g. tongs or screwdriver).
X Make sure the chips guard is working.
Restarting the machine following blockage!
Diverse physical injuries and material damage.
X In the event of a blockage, always disconnect the machine from the power supply before
clearing it.
X If necessary, remove any tensioned parts before restarting the machine.
Vapors when working with lubricants!
Damage to lungs, skin and the environment.
X Only use original lubricant recommended by Orbitalum Tools.
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN