ITW Orbitalum GF 4 Traduction Du Mode D'emploi Original page 70

enGLISH
Features and scope of application
Line laser to display cut-off point
Reversible clamping jaws
Clamping jaw assembly, see chap. 8.4,
p. 80.
Plug connection with
quickdisconnect
coupler
Optimized chip guard
Stainless steel clamping
attachment
70
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
To mark the cut-off point on the pipe.
Ideal for checking whether the pipe is
adjusted to the desired cut-off point.
A red line that marks the cut-off point
appears on the clamped pipe once the red
button on the line laser has been pressed.
If necessary, the pipe position can be
corrected until the desired cut-off point is
marked.
The reversible clamping jaws are a standard
feature of the GF 4 (AVM/MVM). Turning
the clamping jaws allows the following pipe
diameters to be processed:
PIPe OD [MM] PIPe OD [IncH]
12 - 56 / 0.472 - 2.205 /
20 - 120 0.787 - 4.724
For easy and comfortable replacement
of power cables.
Optimized chip guard protects against
flying chips and comes with a meter rule
slot for measuring the pipe length (GF 4
only).
Ideal for processing stainless steel pipes.
For protection against contact corrosion.
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN