ITW Orbitalum GF 4 Traduction Du Mode D'emploi Original page 80

enGLISH
Set-up and assembly
8.4 GF 4: Fitting the clamping
jaws
Clamping jaw characteristics, see chap. 4.2, p. 69.
8.4.1 Fitting the clamping jaws
1. Loosen the hexagon bolt on the side of the vice using a
multifunctional wrench (1).
2. Insert the clamping jaws.
3. Tighten hexagon bolts.
8.5 Fitting the saw blade, bevel cutter, additional cutters
WARnInG!
WARnInG!
ATTenTIOn!
IMPORTAnT!
80
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
When switching the motor on, the pipe cutter may revolve around the pipe
automatically!
Diverse physical injuries and material damage.
X In their home position, the saw blade or bevel cutter must not touch the pipe.
X Make sure that the slide housing is in the home position when the cutting process starts.
X Clamp the pipe to be cut into the vice.
X Pull off the multifunctional wrench from the spindle before the slide housing starts rotating.
X Before switching the motor on, make sure that the gap between the saw blade/bevel
cutter and the pipe is sufficient, and that the pipe is securely clamped in the vice.
X Place sufficient supports under the tube (see chap. 8.1.3, p. 78).
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the pipe while it is loose in the vice.
X never use a damaged or deformed saw blade or bevel cutter.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool can
break again (for details of what to do in the event of tool breakage, see chap. 10.4.1, p. 100).
X Clamp the pipe to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Pipe dimension must be set correctly. During cutting, the saw blade must saw through
the entire pipe wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.6,
p. 82) and speed (see chap. 8.7, p. 85) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
Damage to material!
X When using an additional cutter, only use the special Orbitalum Tools clamping plate
(code 790 046 188); not the clamping plate supplied as standard with the cutters.
X never use a damaged or deformed saw blade or bevel cutter.
X The saw blade or bevel cutter must be free from chips and dirt.
X Only use original tools by Orbitalum Tools.
X Mount the saw blade/bevel cutter or additional cutter with the inscription facing you.
The teeth will then be pointing in the correct direction.
Before fitting the saw blade or bevel cutter: Move the slide (9) all the way down
using the hand wheel (8).
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
1
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN