ITW Orbitalum GF 4 Traduction Du Mode D'emploi Original page 81

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
8.5.1 Inserting the saw blade or bevel cutter
1. Turn the chip guard (1) down for approx. 90°.
2. Loosen the hexagon nut (4). Remove the clamping plate (3) and the saw blade (2).
3. Clean the saw blade shaft (6) and vicinity with a brush.
4. Fit the saw blade (2) or bevel cutter and the clamping plate (3).
5. Tighten the hexagon nut (4) a fraction.
6. Move the saw chip guard (1) back to its original position.
8
9
nOTe!
8.5.2 Inserting the saw blade/bevel cutter combination
1. Turn the chip guard (1) down for approx. 90°.
2. Loosen the hexagon nut (5). Remove the clamping plate and the saw blade.
3. Clean the saw blade shaft (6) and vicinity with a brush.
4. Fit the additional cutter (2), the saw blade (3) and the special clamping plate (4) (Code 790 046 188).
5. Tighten the hexagon nut (5) a fraction.
6. Move the saw chip guard (1) back to its original position.
7
nOTe!
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
7
Make sure that the felt ring (7) is on the locking sleeve.
6
Make sure that the felt ring (7) is on the locking sleeve.
Set-up and assembly
6
6
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
6
81