Correct Connection; Proper Use - Cleanmaxx VC-S1001 Mode D'emploi

Correct Connection

❐ The device must be connected only to mains sockets that have been properly installed.
The socket must also be readily accessible after connection. The mains voltage must
match the technical data for the device (see the "Technical Data" chapter). Only use
suitable extension cables whose technical data is the same as that of the device.
❐ Ensure that it is not possible for others to trip over the connected mains cable.
❐ Position the cable in such a way that it does not become squashed or bent and does
not come into contact with hot surfaces.

Proper Use

❐ The device should only be used in closed rooms. Do not operate it outdoors or in
rooms with high humidity.
❐ If you wish to use the device as a hand-held vacuum cleaner for cleaning a car, en-
sure that device and the cable are not exposed to rain or moisture.
❐ Always check the device for damage before putting it into operation. If the device,
cable and/or plug shows visible signs of damage, the device must not be used. Do
not try to repair the device yourself or to replace any individual parts. In the event of
any damage, please contact our customer service department.
❐ Do not use the device if it has malfunctioned, sucked up liquids or objects or been
dropped. Have the device checked by a specialist or contact the customer service
department.
❐ The device should only be used when it is fully and correctly assembled. The dust
container and fi lters must be inserted.
❐ Do not immerse the device in water or other liquids in order to avoid electric shocks.
❐ Never touch the device, cable or plug with wet hands.
❐ Do not expose the device to extreme temperatures, wide temperature fl uctuations,
open fi re, direct sunlight, moisture or wet conditions.
❐ Do not drop the device or allow it to be knocked violently.
❐ Do not suck up any liquids and do not pour any liquids into the dust container.
❐ Do not insert anything into the openings/nozzles of the device and make sure that
these do not become clogged.
❐ Never leave the device unattended when it is switched on or connected to the mains.
❐ Switch the device off immediately and pull the mains plug from the mains socket
– if you stop working with the device for a period of time,
– if you are no longer using the device,
– before you change the nozzles and other accessories,
– if a fault or error occurs while the device is in operation,
– if liquids or foreign bodies have found their way into the device,
– before a thunderstorm,
❐ The device must be switched off when inserting or removing the mains plug.
16