ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
COMPONENT
Mains Lead
Pads
Handle and Deck
This Product meets the requirements of IEC 60335 - 2-67
Inrush current can cause short-time voltage drops. In unfavorable power supply conditions, other
equipment connected to the supply network may be adversely effected. Ensure the supply impedance is
less than 0.31 Ohm, to avoid disturbances.
WARNING
This Machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories,
shops, rental businesses and offices.
Care should be taken in the choice of chemicals, detergents and other liquids. Consult your supplier for advice.
This appliance is not intended for use by persons (including children) with reduced physical sensory or mental
capabilities, or lack of experience and knowledge. Unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
DO
Ensure only competent persons unpack/ assemble the machine.
DO
Keep your machine clean.
DO
Keep your brushes in good condition.
DO
Replace any worn or damaged parts immediately.
DO
Daily examine the mains lead for damage, such as cracking or ageing. If damage is found, replace the lead
before further use.
DO
Only replace the mains lead with the correct Numatic approved replacement part.
DO
Ensure that the work area is clear of obstructions and/ or people.
DO
Ensure that the working area is well illuminated.
DO
Pre - sweep the area to be cleaned.
DON'T
Use steam cleaners or pressure washers to clean the machine or use in the rain.
DON'T Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
DON'T Allow any inexperienced repairs. Contact your nearest service centre.
DON'T
Strain the mains lead or try to unplug by pulling on the mains lead.
DON'T
Expect the machine to provide trouble free, reliable operation unless maintained correctly.
DON'T
Run the machine over any power cables during operation.
DON'T
Leave your machine standing on brush, pads or drive boards when not in use.
Operators shall be adequately instructed on the use of this machine.
This machine shall be disconnected from its power source (Remove plug from socket outlet.) During
cleaning or maintenance or in the event of an accident and when replacing parts or converting the
machine to another function.
CAUTION
This machine is not suitable for picking up hazardous dust.
Do not allow supply cord to come into contact with the rotating brushes or pads
As with all electrical equipment care and attention must be exercised at all times during its use, in addition to ensuring
that routine and preventive maintenance is carried out periodically in order to ensure its safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render
the equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the model number / serial number specified on the rating plate.
This machine is for indoor use only.
The machine is not to be used or stored outdoors or in wet conditions.
Don't allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
Only use brushes provided with the appliance or those specified in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine, for the specific task being
performed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
Information for Scrubber Dryer
INTERVAL
DAILY
BEFORE EACH USE
BEFORE EACH USE
INSPECT FOR
Scuffing, cracks, splits, conductors showing
Damage and wear
Wear, cracks, splits
T 01460 68600
10