To Insert And Remove The Batteries - Petsafe PBC17-14779 Manuel D'utilisation

To Insert and Remove the Batteries

Note: Do not install the batteries while the Indoor Bark
Control is turned on.
1. Holding the grooved edges, slide the Battery Tray out (A).
2. Install two (2), 3-Volt (CR2032) batteries positive (+) side
up (B).
3. Slide the Battery Tray back in place (C).
To Verify the Batteries are Inserted
Correctly
1. Slide the On/Off Switch to ( | ) ON (D).
2. The LED should flash green once and there will be an
audible beep. Then the LED will flash green once every 5
seconds (E).
3. If the LED does not flash, you may have inserted the
batteries backwards. Try taking them out and turning them
over, ensuring that the (+) side is up.
4. If the LED still does not flash, contact the Customer Care Centre.
Replacement batteries (3-Volt, CR2032) can be found at many retailers. Contact the
Customer Care Centre or visit our website at www.petsafe.net for a list of common retailers.
8 www.petsafe.net
B
A
E
C
D