Prepare The Receiver Collar; To Insert And Remove The Batteries - Petsafe PDT20-10644 Manuel D'utilisation

Step

Prepare the Receiver Collar

2
Your Receiver Collar comes with short Contact Points installed. Use the long Contact
Points for pets with long or thick hair. Tighten the Contact Points with the Test Light
Tool one-half turn beyond fi nger tight (2A). Check the tightness weekly.

To Insert and Remove the Batteries

1. Remove the screws with a small Phillips screwdriver (2B, 2D).
2. For the LDT-433 only, push the Battery Lid up according
to the arrows stamped on the Battery Lid (2B).
3. Slide the Battery Lid out.
4. Install two (2), 3-volt batteries positive (+) side up (2C, 2E).
5. Slide the Battery Lid into the Receiver Collar.
6. Reinstall the screws (2C, 2F). Do not over-tighten the screws.
Replacement batteries (Petsafe
many retailers. Contact the Customer Care Centre or visit our
website at www.petsafe.net for a list of common retailers.
2B (LDT-433)
2D (BDT-433)
8
®
RFA-35-11) can be found at
2C (LDT-433)
2E (BDT-433)
Receiver Collar
www.petsafe.net
Batteries
Batteries
2A
2F (BDT-433)
Waterproof
Seal