Prepare The Receiver Collar; To Insert And Remove The Batteries - Petsafe BDT-433 Manuel D'utilisation

Step

Prepare the Receiver Collar

2
Your Receiver Collar comes with short Contact Points installed. Use the long Contact
Points for pets with long or thick hair. Tighten the Contact Points with pliers one-half
turn beyond fi nger tight (2A). Check the tightness weekly.

To Insert and Remove the Batteries

1. Remove the screws with a small Phillips screwdriver (2B).
2. For the LDT-433 only, push the Battery Lid up according
to the arrows stamped on the Battery Lid (2B).
3. Slide the Battery Lid out.
4. Install two (2), 3-volt batteries positive (+) side up (2C, 2E).
5. Slide the Battery Lid into the Receiver Collar.
6. Reinstall the screws (2C, 2F). Do not over-tighten the screws.
Replacement batteries (3-volt, CR2032) can be found at
many retailers. Contact the Customer Care Centre or visit our
website at www.petsafe.net for a list of common retailers.
2B (LDT-433)
2D (BDT-433)
6
2C (LDT-433)
2E (BDT-433)
Receiver Collar
www.petsafe.net
Batteries
(CR2032)
Batteries
(CR2032)
2A
2
3
2F (BDT-433)
Waterproof
2
3
Seal