Operating Guide; Prepare The Remote Transmitter; To Insert And Remove The Batteries - Petsafe ST-70 Manuel D'utilisation Et De Dressage

OPERATING GUIDE

STEP 1

Prepare the Remote Transmitter

To Insert and Remove the Batteries

1. Slide off the battery cover (1A).
2. Install two (2), 3-volt lithium CR2032 batteries positive (+) side up (1B).
3. Slide the battery cover back in place (1C).
To Verify the Batteries are Inserted Correctly
1. Press any button on the Remote Transmitter.
2. The Remote Transmitter LED should fl ash to indicate a button has been pressed.
3. If the Remote Transmitter LED does not fl ash, you may have inserted the batteries backwards.
Try taking them out and turning them over, ensuring that the positive (+) side is up.
4. If the Remote Transmitter LED still does not fl ash, contact the Customer Care Centre.
Remote Transmitter LED - Function and Response
Function
Unit is on
Low battery condition
1A
Risk of explosion if batteries are replaced by an incorrect type. Do
not short circuit, mix old and new batteries, dispose of in fi re, or
expose to water. When batteries are stored or disposed, they must
be protected from shorting. Dispose of spent batteries properly.
LED Light Response
On for length of button press
LED fl ashes 3 times every 5 seconds
www.petsafe.net
1B 1C
7