Midland BTX2 PRO S Guide D'utilisation page 26

previous connection will be closed. The connection is not a "chain", when two
persons are talking it is not possible to break (interrupt) the communication by
one of the other two units.
Pair the Midland BTX2 PRO S to another Midland BTX2 PRO S unit
To pair the Midland BTX2 PRO S to another Midland BTX2 PRO S unit, you
must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is
on permanently.
3. Now press one of the three buttons (Forward, Middle or Backward) for 3
seconds depending on which button you would like use to open the inter-
com to the other unit. The Blue and Red lights will flash.
4. Repeat the same procedure on the other unit, you don't need to use the
same button, you can choose one of the three buttons not previously used.
5. When successfully paired, each unit will have the Blue light on for one se-
cond and then go back to the setup mode (Red light always on).
6. Now the unit is ready for another pairing procedure, and you can pair
another Midland BTX2 PRO S unit following the same procedure, but using
a different button.
If you don't have more devices to pair, you must exit the setup mode before
you can use the units:
› Double click on the Middle button, the Red light will turn off and the Blue
light will start flashing. You can use now your Midland BTX2 PRO S
A- Manual activation
Mode Forward button
Short press: Open/Close intercom to paired
Intercom
raider
24
How to use the Intercom with more than two units
To use the intercom feature, be sure that all the units are turned on and cor-
rectly paired together.
Manual activation in Intercom mode
When in "Intercom Mode" press the button corresponding to the unit you
would like to communicate with. After some seconds the intercom commu-
nication will open. The communication remains active until you press again
the same button. To quickly open the intercom to another person, just press
the button corresponding to the other unit, the intercom will be automatically
closed and the new connection will be open (see Table A).
Voice activation (VOX)
The voice activation feature can open the intercom only to the unit paired to
the Middle button.
Hint: this feature is very useful when you have a specific person that you like to
talk to more often (for example your passenger). In this way you don't need to
press a button to open the communication.
Unit already busy in a conversation
If you try to open an intercom connection to another person that is already
talking with someone else (or is in a middle of a phone conversation), you will
hear a "busy" double beep tone. Just wait sometime and try again, maybe this
time the "line" is not busy.
The person who is called, will be advised that someone is trying to call and will
hear a voice announcement with the number of the button from which the
Middle button
Short press: Open/Close intercom to paired
raider
Long press: Change mode
Rear button
Short press: Open/Close intercom to paired
raider
www.midlandeurope.com