Maximum Distance; How To Pair Two Midland Btx2 Pro S Units - Midland BTX2 PRO S Guide D'utilisation

› You can switch (toggle) from one mode to the other simply pressing the
Middle button for 3 seconds. A voice announcement will tell in which mode
you are on.
The toggle sequence is the following:
› Intercom mode (if another unit has been paired)
› FM Radio
› Phone mode (if a phone has been paired)
Every time you turn on the unit, the default mode is the last used mode.
The Intercom mode and Phone mode are avalaible only if it was previously pai-
red to another unit or to a phone.
If you need to know in which mode the unit currently is, just press the "Volume
+ " and "Volume –" button together. A voice announcement will tell you the
current mode.

Maximum Distance

You can reach 1.2 Km intercom distance if you are in line of sight without ob-
structions and interferences (the riders must be always in sight).

How to pair two Midland BTX2 PRO S units

The two units supplied in the same Midland BTX2 PRO S box, are already
paired and ready to use, this means you don't need to perform this procedure.
The units are already paired using the Middle button.
If the devices are not part of the same kit, or the units has been purchased
separately, you need to first pair them in order to use them.
Here is an example of the buttons main functionality based on the mode you are on.
Mode Forward (Left button)
Intercom Open/close the intercom to the first rider
Phone Redial last number/accept or reject
incoming call on "Vol+"
Phone (while music play) Forward the song
FM Radio Scan up
22
To pair the Midland BTX2 PRO S to another Midland BTX2 PRO S unit
To pair the Midland BTX2 PRO S to another Midland BTX2 PRO S unit, you
must first enter the setup mode:
1. Turn off the unit.
2. Press and hold down the middle button about 7 sec., until the Red light is
on permanently.
3. Now press the Middle button for 3 seconds. The Blue and Red lights will
flash.
4. Do the same procedure on the other unit. When successfully paired, each
unit will have the Blue light on for one second and then go back to the setup
mode (Red light always on).
5. Now the pairing procedure is complete, you just need to exit the setup
mode before you can use the units.
6. Double click on the Middle button, the Red light will turn off and the Blue
light will start flashing.
You can use now your Midland BTX2 PRO S
Attention: remember to switch off all the other Bluetooth devices that are not
part of the pairing procedure, only the two devices involved in the pairing must
be turned on.
How to use the Intercom with two units
To use the intercom feature, be sure that both units are turned on and cor-
rectly paired together.
Middle button
Open/close the intercom to the second
rider
Play/pause
FM Radio On/off
Rear (Right button)
Open/close the intercom to the Third rider
Redial last number/accept or reject
incoming call on "Vol-"
Backward the song
Scan down
www.midlandeurope.com