How To Listen To The Fm Radio - Midland BTX2 PRO S Guide D'utilisation

› Volume - button (support for stereo A2DP audio and HFP mono).
All devices paired on "Vol -" button are always active in background during
the Intercom communication. You can decide if the audio from the "Vol -"
connection is shared with other people when the intercom is open ("Public"
feature on) or if it must be private ("Private" feature on). See the "Back-
ground" paragraph above.
GPS Stereo (A2DP) voice announcement
Midland BTX2 PRO S supports Stereo (A2DP) voice announcement from
GPS Navigators or smartphone application on both "Vol+" or "Vol-" con-
nection. When connected on "Volume +" button, the GPS street voice an-
nouncements will interrupt all other communication. Only when connected
on "Vol-" the GPS voice announcements are in backgroud.
How to pair the Midland BTX2 PRO S to a GPS
In general it is possible to pair the Midland BTX2 PRO S to all the GPS for
motorbike that support Bluetooth headset connection.
To pair the Midland BTX2 PRO S to a GPS, you must first enter the setup
mode:
1. Turn off the unit
2. Press and hold down the "Middle" button about 7 sec., until the Red light is
on permanently.
3. Now press firmly (3 sec) the "Volume +" or "Volume -" button, the Blue
and Red lights will flash.
4. Enable the Bluetooth device search feature on your GPS
5. After some seconds, "Midland BTX2 PRO S" will be displayed on your GPS.
6. Follow the pairing procedure of your GPS. If a pin code is requested you
must enter "0000" (four times zero).
When successfully paired, the Blue light of the unit will be on for one second
C-Radio FM mode
Mode
FM Radio
30
Forward button
Short press: seek station up
Long press: Scan recorded
and then the unit will exit the setup mode and switch to the working mode (the
Blue light will start flashing).
You can now use your Midland BTX2 PRO S with the GPS for street voice
announcement.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button.
If paired on "Volume -", the PMR446 radio is always in the background even
when you talk on the intercom.
Pairing procedure
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is
on permanently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red
light will flash.
› Follow now the pairing procedure explained on the manual of the transcei-
ver itself

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch to
the "FM Radio" mode in order to use it.
Long press the middle button until you hear "FM radio" from the voice an-
nouncement. Now all the three main buttons are dedicated to the FM Radio
(See Table C).
Press short the "Forward" or the "Backward" button to seek the FM Radio
station. When you press long the Forward or the Backward button, you can
scan up or down the 6 recorded stations.
A voice announcement will tell you the number of which memory you are en-
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
www.midlandeurope.com